Kia Optima: Child seat anchorage position - Installing a Child Restraint System in the Rear Center Seat - Safety Belts - Knowing your vehicle - Kia Optima MS/Magentis 2000-2005 Owners ManualKia Optima: Child seat anchorage position

For small children and babies, the use of a child seat or infant seat is strongly recommended. This child seat or infant seat should be of appropriate size for the child and should be installed in accordance with the manufacturer’s instructions. It is further recommended that the seat be placed in the vehicle’s rear seat since this can make an important contribution to safety. Your vehicle is provided with three child restraint hook holders on the package tray behind the rear seat for installing the child seat or infant seat.

WARNING - Child Restraint Placement WARNING - Child Restraint Placement

Never use a child restraint in the front passenger seat. A child in a child restraint installed in the front passenger seat can be severely or fatally injured by an air bag which could impact the child restraint with great force when the air bag inflates.

Installing a Child Restraint System in the Rear Center Seat
To install a child restraint in the rear center seat, do the following: 1. Place the child-restraint in the desired position. Route the lap/ shoulder belt through the restraint according to the s ...

Child restraint anchorage position
Your vehicle is equipped with an anchor for securing the tether strap of a child restraint system (child seat). The child restraint anchor fittings are installed on the shelf behind the rear se ...

See also:

Lumbar support
The lumbar support can be adjusted by pressing the lumbar support switch on the side of the drivers seat. Press the front portion of the switch to increase support, or the rear portion of the sw ...

To increase cruise control set speed
Follow either of these procedures: Move the lever (1) up (to RES+) and hold it. Your vehicle will accelerate. Release the lever at the speed you want. Move the lever (1) up (to RES+) and re ...

If engine turns over normally but does not start
1. Check fuel level. 2. With the ignition switch in the LOCK position, check all connectors at the ignition coil and spark plugs. Reconnect any that may be disconnected or loose. 3. Check th ...

Copyright © www.kiopman.com 2024