Replacement
1. | Remove the cap (B) and remove
the nuts, then remove the wiper arm (A).
|
2. | Disconnect the nozzle hose (B). |
3. | Detach the clips, then remove
the cowl top cover (A).
|
4. | Installation is the reverse of
removal.
|
Safety Belt Warning
As a reminder to the
driver and passenger, safety belt warning light will blink for approximately 6 seconds
each time you turn the ignition switch ON.
If the driver's lap/shoulder belt is not ...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is found, repa ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the fuel pump service cover (A) in the trunk.
3.
...