Kia Optima: Engine Control Module (ECM). Schematic Diagrams

Components and Components Location

Components Location 1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) #1 3. Intake Air Temperature Sensor (IATS) 4. Manifold Absolute Pressure Sensor ...

ECM Terminal And Input/Output signal

ECM Terminal Function Connector [CHTG-AG] Pin No. Description Connected to 1 Ignition Coil (Cylinder #2) control output [W ...

See also:

Changing the Automatic Transaxle Fluid
1. Raise and suitably support the vehicle. 2. Remove the drain plug located at the bottom center front of the transaxle pan. 3. After the oil has drained, completely install a new washer on the plug ...

System Operation
Ventilation 1. Set the mode selection switch to the position. 2. Set the air intake control switch to the outside air position. 3. Set the temperature control knob to the desired position. 4. Se ...

Additional Programming for Rolling Code Devices
For any rolling-code-equipped device; follow the steps below after completing the "Programming" section. A second person may make the following steps easier. 1. Locate the "learn&quo ...