Kia Optima: Installation
| 1. |
Install the washer reservoir.
|
Before installing the pump motor, check the filter for foreign material
or contamination. if necessary, clean the filter into the pump motor. |
|
| 2. |
Install the washer motor. |
| 3. |
Install the washer hose. |
| 4. |
Connect the washer motor connector
and level sensor connector. |
| 5. |
Install the front bumper. |
| 6. |
Check the washer motor operation. |
-
When servicing the washer
pump, be careful not to damage the washer pump seal.
-
Do ...
See also:
Removal
Parking Assist Sensor
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the rear bumper.(Refer
to the BD group - "Rear bumper")
3.
...
TCM Terminal Input/ Output Signal
Connector [CHTG-AG]
Pin
Description
Condition
Input/output value
Type
Level
1
-
...
Installation
1.
Make sure of the length of compressor
mounting bolts, and then tighten it A→B→C→D order.
Tightening torque :20.0~32.9N.m
(2.04~3.36kgf.m, 14.7~24 ...
Removal
Rain Sensor. Schematic Diagrams