Kia Optima: Installation

Removal

1. Disconnect the negative(-) battery terminal. 2. Remove the heater comtral module. (Refer to the HA group - "Controller") ...

Rheostat. Repair procedures

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. ...

See also:

Measuring Body Dimensions
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is no elongation, twis ...

Installation
Side Repeater Lamp 1. Install the bulb to the side repeater lamp assembly. 2. Install the side repeater lamp. Door Mirror Turn Signal Lamp 1. Install the do ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and i ...