Kia Optima: Parking Brake and Brake Fluid Warning - Warnings and Indicators - Driving Your Vehicle - Kia Optima MS/Magentis 2000-2005 Owners ManualKia Optima: Parking Brake and Brake Fluid Warning

This light comes ON when the parking brake is applied with the ignition switchParking Brake Warning

This light comes ON when the parking brake is applied with the ignition switch in the START or ON position. The warning light should go off when the parking brake is released.

Low Brake Fluid Level Warning

If the warning light remains ON when the parking brake is released, it may indicate that the brake fluid level in the reservoir is low. If the warning light remains ON:

1. Drive to the nearest safe location and carefully stop your vehicle.

2. With the engine stopped, check the brake fluid level immediately and add fluid as required. All brake components should also be checked immediately for fluid leaks.

3. If leaks are found, if the warning light remains on, or if the brakes do not operate properly, do not drive the vehicle. Have it towed to an Authorized Kia Dealer or other competent repair shop for a brake system inspection and necessary repairs.

WARNING - Brake Warning Lights WARNING - Brake Warning Lights

Driving the vehicle with a warning light ON is dangerous. If the brake warning light remains ON, have the brakes checked and repaired immediately.

To check bulb operation, the warning light illuminates when the ignition switch is in the ON position.

Warning Lights/Audible Indicators Checking Operation
All the warning lights, except the brake warning light, are checked by turning the ignition switch ON (you do not need to start the engine). Any light that does not come on should be checked by an ...

Safety Belt Warning
As a reminder to the driver and passenger, safety belt warning light will blink for approximately 6 seconds each time you turn the ignition switch ON. If the driver's lap/shoulder belt is not ...

See also:

Power Seat Control Switch. Schematic Diagrams
Circuit Diagram ...

Removal
1. Disconnect the negative(-) battery terminal. 2. Remove the glove box.(Refer to the BD group - "Crash pad") 3. Disconnect the fob hold ...

Inspection
With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. A : Power seat control s ...

Copyright © www.kiopman.com 2024