The use of the auto lock mode will ensure that the normal movement of the child in the vehicle does not cause the safety belt to be pulled out and loosen the firmness of its hold on the child restraint system. To secure a child restraint system in the front passenger seat or rear outboard seats, use the following procedure.
If engine turns over normally but
does not start
1. Check fuel level.
2. With the ignition switch in the LOCK
position, check all connectors at the
ignition coil and spark plugs.
Reconnect any that may be disconnected
or loose.
3. Check th ...
Troubleshooting
Troubleshooting
Symptom
Probable cause
Remedy
Play in steering
Loose yoke plug
Retighten
Loose steering gear ...
Inspection
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
3.
...