Kia Optima: Rail Pressure Sensor (RPS). Description and Operation
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure and the actual pressure calculated by the RPS output signal are different.
Installation
•
Install the component with the specified
torques.
•
Note that internal damag ...
Rail Pressure Sensor (RPS). Specifications
Specification
...
See also:
Owner maintenance schedule
When you stop for fuel:
Check the engine oil level.
Check the coolant level in coolant
reservoir.
Check the windshield washer fluid
level.
Look for low or under-inflated tires.
Whil ...
Heater Unit. Repair procedures
Replacement
1.
Disconnect the negative (-) battery
terminal.
2.
Recover the refrigerant with
a recovery/ recycling/ charging station.
3.
When the e ...
Component Location Index
Engine Room
1. Receiver Drier
2. Condenser
3. Service Port (High)
4. Service Port (Low)
5. A/C Pressure Transducer
6. Compressor
7. Expansion Val ...
Copyright © www.kiopman.com 2024