Kia Optima: Removal

1.	Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group).

2.	Remove the fuel pump service cover (A) in the trunk.

3.	Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).

4.	Disconnect the fuel feed tube quick connector (C).

5.	Lift the vehicle and support the fuel tank with a jack.

6.	Remove the center muffler assembly (Refer to “Intake And Exhaust System” in EM group).

7.	Disconnect the fuel filler hose (A).

8.	Disconnect the vapor hose quick-connector (A).

9.	Remove the parking brake line (A).

10.	Remove the fuel tank band installation nuts (A).

11.	Remove the fuel tank after removing the fuel tank band (A) as below.

Fuel Tank. Repair procedures

...

Installation

1. Installation is reverse of removal. Fuel tank band installation nut: 39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft) ...

See also:

Inspection
[Fuel pump] 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump assembly. 3. Check motor operatio ...

Mode selection
The mode selection button controls the direction of the air flow through the ventilation system. Every time you press the mode selection button, the mode will change as follows: Refer to the i ...

Removal
1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the roof trim. (Refer to the Body group- Interior) ...

Categories

Kia Optima Manuals

Copyright © www.kiopman.com 2025