Kia Optima: Removal
| 1. | Remove the ignition key from the vehicle. |
| 2. | Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
| 3. | Remove the floor console. (Refer to the Body group - console) |
| 4. | Pull up the lock (C), of the
SRSCM connector, the disconnect the connector (A and B).
|
| 5. | Remove the SRSCM mounting nuts from the SRSCM, then remove the SRSCM. |
Installation
1.
Remove the ignition key from
the vehicle.
2.
Disconnect the battery negative
cable and wait for at least three minutes before beginning work.
3.
In ...
See also:
Warnings and indicators
All warning lights are checked by turning the ignition switch ON (do not start
the engine). Any light that does not illuminate should be checked by an authorized
Kia dealer.
After starting the en ...
Multimedia Jack. Schematic Diagrams
Circuit Diagram
...
Hazard Warning Flasher
The hazard warning flasher causes the rear tail lights and front turn signal
lights to flash on and off, which serves as a warning to other drivers to exercise
caution when approaching or passin ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2025 Owners Manual
- Kia Optima DL3 2019-2025 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2025 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright © www.kiopman.com 2025