1. | 1. Disconnect the negative (-) battery terminal. |
2. | Remove the main crash pad lower
cover (A).
|
3. | Disconnect the power mosfet connector
(A) and then remove the power mosfet (B) after loosening the mounting screws.
|
4. | Installation is the reverse order of removal. |
SS-B Solenoid Valve(ON/OFF). Description and Operation
Description
SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve
that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve
body.
...
Ignition Switch and Anti-Theft Steering Column Lock
Ignition Switch Positions
LOCK
The steering wheel locks to protect against theft. The ignition key can be removed
only in the LOCK position. When turning the ignition switch o the LOCK position, ...
Reassembly
1.
Wrap tape around the driveshaft
spline(TJ) to prevent damage to the boots.
2.
Apply grease to the joint boot
on the side of the wheel and install the boot.
...