Kia Optima: Replacement
Standard values, such as torques and certain adjustments, must be strictly
observed in the reassembly of all parts.
If removed, the following
parts should always be replaced with new ones.
| 5. |
Cotter pins (split pins) |
| 6. |
Plastic nuts
Depending on their location. |
| 7. |
Sealant should be applied
to gaskets. |
| 8. |
Oil should be applied to
the moving components of parts. |
| 9. |
Specified oil or grease
should be applied to the prescribed locations (oil seals, etc) before assembly.
|
When replacing parts, use KIA MOTORS genuine parts.
...
Use gauges and testers to adjust correctly the parts to standard values correctly. ...
See also:
ODS (Occupant Detection System)
Your vehicle is equipped with an ODS in the front passenger's seat.
The ODS is designed to detect the presence of a properly-seated front passenger
and determine if the passenger's front ...
Inspection
1.
Check signal waveform of Input
& output speed sensor using the GDS.
Specification: Refer to "Signal
Wave Form" section.
...
Removal
1.
Disconnect the negative(-) battery
terminal.
2.
Remove the rear seat.(Refer
to the BD group - "Rear seat")
3.
Remove the package tray ...
Parts
Adjustment