Kia Optima: 35R Clutch Control Solenoid Valve(35R/C_VFS). Description and Operation
Description
35R clutch control solenoid valve(35R/C_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 35R clutch.
- 35R Clutch Control Solenoid Valve(35R/C_VFS). Specifications
- 35R Clutch Control Solenoid Valve(35R/C_VFS). Schematic Diagrams
- 35R Clutch Control Solenoid Valve(35R/C_VFS). Repair procedures
- Underdrive Brake Control Solenoid Valve(UD/B_VFS). Description and Operation
- Underdrive Brake Control Solenoid Valve(UD/B_VFS). Specifications
- Underdrive Brake Control Solenoid Valve(UD/B_VFS). Schematic Diagrams
- Underdrive Brake Control Solenoid Valve(UD/B_VFS). Repair procedures
- Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Description and Operation
- Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Specifications
- Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Schematic Diagrams
- Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures
- SS-A Solenoid Valve(ON/OFF). Description and Operation
- SS-A Solenoid Valve(ON/OFF). Specifications
- SS-A Solenoid Valve(ON/OFF). Schematic Diagrams
- SS-A Solenoid Valve(ON/OFF). Repair procedures
- SS-B Solenoid Valve(ON/OFF). Description and Operation
- SS-B Solenoid Valve(ON/OFF). Specifications
- SS-B Solenoid Valve(ON/OFF). Schematic Diagrams
- SS-B Solenoid Valve(ON/OFF). Repair procedures
- Inhibitor Switch. Description and Operation
- Inhibitor Switch. Specifications
- Inhibitor Switch. Schematic Diagrams
- Inhibitor Switch. Repair procedures
- Shift Lever. Components and Components Location
- Shift Lever. Repair procedures
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pre ...
35R Clutch Control Solenoid Valve(35R/C_VFS). Specifications
Specifications
Direct control VFS[35R/C]▷ Control type : Normal low type
Control Pressure kpa(kgf/cm², psi)
500.14~9.81(5.1~0.1,72.54~1.42)
Curren ...
See also:
Installation
1.
Install the overhead console
lamp after connecting the sunroof switch connector and lamp connector.
2.
Install the lens after tightening
2 screws.
...
Anti-Lock Brake System (ABS) Warning Light
This light illuminates
when you start the engine. The light will go off if the ABS is operating normally.
Also, this light comes on if the key is turned to ON, and then goes off in 2-3 seconds
i ...
Component Location (1)
1. Buzzer
2. RF receiver
3. Smart key unit
4. Interior antenna 1
5. Interior antenna 2
6. Trunk antenna
7. Bumper antenna
...
Copyright © www.kiopman.com 2024