Kia Optima: Reassembly
| 1. |
Install the hub bearing to the
knuckle assembly.
| (1) |
Lay the knuckle assembly
(A) on press. |
| (2) |
Lay a new hub bearing
upon the knuckle assembly (A). |
| (3) |
Lay a suitable adapter
(B) upon the hub bearing. |
| (4) |
Install the hub bearing
to the knuckle assembly by using press. |
| -
|
Do not press
against the inner race of the hub bearing because that can
cause damage to the bearing assembly. |
| -
|
Always use a
new wheel bearing assembly. |
|
|
| 2. |
Install the hub assembly to the
knuckle assembly.
| (1) |
Lay the hub assembly
(A) upon a suitable adapter . |
| (2) |
Lay the knuckle assembly
(B) upon the hub assembly (A). |
| (3) |
Lay a suitable adapter
(C) upon the hub bearing. |
| (4) |
Install the hub assembly
(A) to the knuckle assembly (B) by using press. |
|
Do not press against the inner race of the hub bearing because that
can cause damage to the bearing assembly. |
|
| 3. |
Install the snap ring (A).
|
1.
Remove the snap ring (A).
2.
Remove the hub assembly from
the knuckle assembly.
(1)
Install the front knuckle
assembly (A) on press.
...
See also:
Repair procedures
...
Don't let your parking brake
freeze
Under some conditions your parking
brake can freeze in the engaged position.
This is most likely to happen when there
is an accumulation of snow or ice around
or near the rear brakes or if the ...
Anti-Lock Brake System (ABS) Warning Light
This light illuminates
when you start the engine. The light will go off if the ABS is operating normally.
Also, this light comes on if the key is turned to ON, and then goes off in 2-3 seconds
i ...
Disassembly