Kia Optima: Removal
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Remove the lower (A) after loosening
the mounting screws. (Refer to the BD group - "Crash pad")
|
| 3. | Remove the heater control unit contained the windshield deicer switch from the center fascia lower panel. |
Inspection
1.
The windshield deicer switch
inputs can be checked using the GDS.
2.
To check the input value of windshield
deicer switch, select option "Body Control Module& ...
Installation
1.
Install the heater control unit.
2.
Install the center fascia lower
panel.
3.
Install the crash pad garnish.
...
See also:
ECM Terminal And Input/Output signal
ECM Terminal Function
Connector [CHTG-AG]
Pin
No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output [W ...
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection ProcedureMeasuring Condition of Electronic Parts' Resistance
The measured resistance at hi ...
Installation
1.
Remove the ignition key from
the vehicle.
2.
Disconnect the battery negative
cable and wait for at least three minutes.
3.
Tighten the curtain airb ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2025 Owners Manual
- Kia Optima DL3 2019-2025 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2025 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright © www.kiopman.com 2025